<p id="cuqpr"><strong id="cuqpr"><small id="cuqpr"></small></strong></p>
  1. <table id="cuqpr"><strike id="cuqpr"></strike></table>
    <pre id="cuqpr"><strong id="cuqpr"><xmp id="cuqpr"></xmp></strong></pre>

      產品中心
      新聞動態 當前位置:首頁>新聞動態>新聞動態

      鋼筋直螺紋滾絲機刀具重磨與更換

      網址:www.blackpoolcc.com  2021-03-29  作者:admin    閱讀:


      1.剝肋刀切削一定數量鋼筋,刀刃會變鈍,此時應將剝肋刀拆下,將刀具的前刃面磨去0.2-0.3mm(嚴禁磨刀刃頂面),安裝后即可重新使用。
      1. When the rib stripper cuts a certain amount of steel bars, the blade will become blunt. At this time, the rib stripper should be removed, and the front edge of the tool should be polished off by 0.2-0.3mm (it is forbidden to grind the top surface of the blade). After installation, it can be reused.
      2.剝肋刀刃口崩裂不能正常切削時,可更換新刀片。
      2. When the edge of the rib stripper is cracked and cannot be cut normally, the blade can be replaced with a new one.
      3.滾絲輪滾軋一定數量的絲頭后,因磨損牙形損壞,不能滾軋出合格絲頭時,應該及時更換新滾絲輪。
      3. After rolling a certain number of thread heads, if the qualified thread heads cannot be rolled out due to the damage of worn teeth, the new thread rollers shall be replaced in time.
      4.在更換新的滾絲輪時,調整螺距的墊圈必須安裝正確,否則不能正常工作 。
      4. When replacing the new thread roller, the washer for adjusting the pitch must be installed correctly, otherwise it cannot work normally.

      返回新聞

      轉讓電話
      13313028229

      最好看的2019年中文视频